Pigtails Connector for 25mm Billet Buttons with LED

Pigtails Connector for 25mm Billet Buttons with RGB LED

25mm A2W PUMP Etched Buttons

24.00$ USD

* 19mm Billet Buttons Picture Shown Temporarily

Material / Finish

Button Type

LED Color

Clear

SKU: N/A Category: 25mm Billet Buttons

These are pre-etched 25mm billet buttons. You can opt to add text on the outer top and bottom portion. Would you have any special instruction or request, you will be able to enter them separate. If we have any question we will get in touch with you before doing any etching. These buttons comes with a pigtail connector for easy wiring and feature a replaceable micro switch and also have a spare slot for an additional micro switch. They have a flat surface and the led move with the button so they are easy to press in. What’s more? They are available with RGB LED for endless possibility!

Custom Outer text;

If you choose to add outer text we will do our regular capital letter etching unless you specify otherwise in the special instruction field. The outer engraving area is smaller on these than on the 22mm model buttons so the text will be smaller.

LED;

These buttons comes with 5 different LED color choice. The LED have independant pin on the button; they can be wired to light with your parking light, when you press the button or just about any configuration you can think of. If you are unsure about which pin does what, take a look at the wiring diagram page.

These model also comes in RGB; if you want a red, a blue or a green button you will be getting an RGB LED button. You will have the choice of these 3 color down the road. The RGB LED share a common anode which mean they are inter-connected to a positive (+12vdc) pin and you must connect to ground the color you want to light. More informations on the RGB LED can be found on the wiring diagram page. Each LED color pin is clearly identified on the buttons.